Sequences H, I, and J: Upwind Baseline (F), Upwind Low Pitch (F), Upwind High Pitch (F) This test sequence used an upwind, rigid turbine with a 0� cone angle. The wind speed ranged from 5 m/s to 25 m/s. Yaw angles of ?30 to 180� were achieved at low wind speeds, and angles of �10� were achieved for high wind speeds. The blade tip pitch was 3� for sequence H, 0� for sequence I, and 6� for sequence J. These three sequences were interleaved during testing because the pitch angle change was easily made by the turbine operator. The rotor rotated at 72 RPM. Blade and probe pressure measurements were collected. The teeter dampers were replaced with rigid links, and these two channels were flagged as not applicable by setting the measured values in the data file to ?99999.99 Nm. The teeter link load cell was pretensioned to 40,000 N. In addition to the standard 30-second campaigns, yaw sweeps were done at 7 m/s and 10 m/s. These 6-minute campaigns were collected while the yaw drive rotated the turbine 360� at a rate of 1�/s. The file names for these campaigns use the letter designation, followed by two digits for wind speed, followed by YS, followed by 000.