The objective of this project was to develop a novel catalytic reactor containing nano-engineered catalysts for the utilization of CO<
sub>
2<
/sub>
(captured from coal-fired power plants and other CO<
sub>
2<
/sub>
emitting sources) in dry methane reforming (DMR) (CO<
sub>
2<
/sub>
+ CH<
sub>
4<
/sub>
? 2 H<
sub>
2<
/sub>
+ 2 CO) to produce synthesis gas (syngas). The technology aims to reduce CO2 emissions by developing beneficial uses for CO<
sub>
2<
/sub>
from coal-fired power plants. It also offers an alternative to mitigate CO<
sub>
2<
/sub>
emissions in areas where geologic storage may not be an optimal solution and/or utilization could significantly offset the costs of carbon capture and sequestration. The nano-engineered Ni-based catalyst was prepared by atomic layer deposition (ALD). The Ni particles were as small as ~2-4 nm. The nano-engineered catalyst showed CH<
sub>
4<
/sub>
conversion >
95%, H<
sub>
2<
/sub>
/CO ratio in the range of 0.7-1.0, and CH<
sub>
4<
/sub>
reforming rate as high as 2,500 L/h/gNi at 850 �C and pressure of 15-25 psia. The Ni-based ALD catalyst also showed good stability in DMR reaction during a 200-h continuous operation at 850 �C. This is due to strong bonding between the nanoparticles and substrates since the Ni nanoparticles were chemically bonded to the substrate during the ALD process. The high thermal stability maintains the high dispersion of Ni nanoparticles, which can inhibit coke formation because their step edges are small enough to limit carbon nucleation and growth. Technoeconomic analysis (TEA) indicates the levelized cost of syngas (LCOS) is $172/ton with our technology, which is lower than the equivalent (molar) cost of hydrogen produced by steam methane reforming (SMR) or autothermal reforming (ATR). The major operating cost is natural gas feed and fuel, and the levelized cost is highly sensitive to the price of natural gas and relatively insensitive to the CAPEX. Revenues from syngas could have a significant impact on the net cost of electricity (COE), depending on the cost of natural gas and the selling price of syngas, estimated at $36 per MWh if the syngas were sold at $195 per ton. Following DOE NETL?s guidance, a lifecycle analysis (LCA) was conducted to compare with SMR. The functional unit for the basis of comparison was defined as 1kg carbon monoxide in the product stream. The global warming potential (GWP) of our process was found to be 40% lower than the state-of-the-art SMR process. The sensitivity analysis confirms the emissions are most sensitive to the natural gas fuel requirements to deliver heat to the process.