Triassic rift basins of the eastern United States present a potential option for long?term carbon dioxide (CO<
sub>
2<
/sub>
) sequestration. Exposed and buried basins are located near large point CO<
sub>
2<
/sub>
sources. Because of their similar origins, comparable fill successions indicate a level of reproducibility that can be conveyed between basins. The thick rock successions of the exposed Culpeper and Gettysburg basins served as proxies for understanding of the basin sequences. Their study allowed recognition of five mappable assemblages of rock types, herein termed lithofacies associations. These lithofacies associations were formed by alluvial fan, braided and meandering streams and marginal and distal lake depositional processes.Stratigraphic architecture of the lithofacies associations within exposed basins suggests a vertical succession that consists of an initial coarse-grained fluvial succession that is progressively replaced upward and basinward by finer grained lacustrine deposits. Along the faulted margins of the basins alluvial fans transitioning to fluvial delta deposits reflect lateral progradation and contemporaneous lateral components of the basin filling.To test the model devised in exposed basins, facies associations were developed for the buried Taylorsville Basin. This basin preserves over 8,000 feet of Triassic rocks that are concealed beneath more than 2,000 feet of Cretaceous and Tertiary Coastal Plain sediments. Composition and stratigraphic architecture of these rocks are similar to those observed in exposed basins. Infilling of the basin was the result of vertical aggradation and lateral progradation of coarse-grained to fine-grained facies. Based upon study of outcrops in the Culpeper and Gettysburg basins, groups of recurring lithologic facies were identified as the fundamental constructs of the basin?s sediment infilling. These groups of facies, termed lithofacies associations, represent an amalgamation of lithologic components from broadly similar depositional systems. These lithologic associations were then extrapolated into the exposed and buried portions of the Taylorsville basins. This effort determined that Triassic rift basins provide several avenues for potential study of geologic sequestration of carbon. The characteristic rift basin succession in the basins presents possible reservoir targets within the marginal fluvial deposits. Furthermore, intrusive and extrusive mafic bodies present a potential source of fracture porosity that could serve as CO<
sub>
2<
/sub>
reservoirs. Porosity values from thin section analysis of exposed basin samples are higher in alluvial fan and braided fluvial lithofacies. Porosity is highest in samples that show less compaction, due to a lack of ductile lithic fragments and/or higher stratigraphic position. Log data from the Taylorsville Basin indicates that porosity and permeability values in basin marginal fluvial strata are elevated. Near the center of the basin, porosity and permeability values are greatly reduced, primarily owing to the fine-grained character of the lacustrine deposits. Some Triassic basins also contain thick intervals of concordant extrusive and intrusive mafic igneous rocks. These igneous bodies are potential CO<
sub>
2<
/sub>
reservoirs for several reasons. Firstly, extrusive lava flows provide potential storage in the layers of primary porosity that occur in the vesicules formed at the top of lava flows. Secondly, both lava flows and subsurface igneous sills exhibit extensive fracture porosity produced by the rapid cooling of the flows and intrusions. Thirdly, these igneous rocks are mafic in composition, and studies have shown that iron- and magnesium-rich mafic rocks provide sequestration opportunities through carbonate remineralization. Lastly, extrusive and intrusive igneous rocks are invariably preserved within fine-grained lake deposits. These lacustrine sediments can serve as a fine-grained confining layer that encases the igneous rocks both above and below.