Nghiên cứu trình bày quy trình tổng hợp vật liệu BiFeO3 bằng phương pháp đốt cháy Gel – Polyme trong điều kiện tối ưu được lựa chọn qua quá trình khảo sát các yếu tố ảnh hưởng và cấu trúc, hình thái vật liệu như: nhiệt độ tạo Gel ở 80oC, tỷ lệ mol kim loại Bi/Fe là 1/1, tỷ lệ mol hỗn hợp kim loại/PVA=1/3, pH=1, nung mẫu ở 500oC trong 2 giờ. Kết quả ứng dụng vật liệu BiFeO3 xử lý 100ml nước thải dệt nhuộm có chứa dung dịch xanh metylen nồng độ 5ppm cho kết quả tương đối tốt với hiệu suất xử lý mẫu ở các điều kiện pha loãng khác nhau (f = 2, 5, 10) là 49 – 65%. Hiệu suất xử lý cao nhất ở điều kiện pha loãng 10 lần với thời gian 120 phút phân hủy dưới ánh sáng UV có bước sóng λ = 285nmThis study presents the process of synthesizing BiFeO3 by the Gel – Polymer combustion method under optimal condition, selected through the investigation of influencing factors and the characteristic of materials, including the Gel formation temperature (80°C), the molar ratio of Bi/Fe (1/1), the molar ratio of the mixture metal/PVA (1/3), pH=1, and the sample is heated at 500oC for 2 hours. Application of BiFeO3 on removal 100ml of textile dyeing wastewater at concentration 5ppm methylene blue shows relatively good results y at different dilution conditions (f = 2, 5, 10) is 49-65% removal efficiency. The highest efficiency has been obtained in condition the sample was diluted 10 times in 120 minutes contact time under ultraviolet light (wavelength λ = 285nm).