Building Automation System (BAS) is currently being applied a lot in modern high-rise building systems. The main objective of the BAS system is to monitor and control all systems in the smart building with a single control system to optimize actual performance. In which the air conditioning system (HVAC) is one of the most important systems in the BAS system. The content of the article presents the results of using Andover Continuum software of Schneider Electric in the work of setting up drivers and designing the monitoring interface for HVAC application of air conditioning system information in PVI building (Hanoi). Through our audience analysis, the authors came up with the algorithm driver
built the transport module modular control and cold water pump pressure according to 2 circuit structure adjustment. Based on the research method of simulation combined with the system experiment, the result shows that the control parameters follow the set value with the error within the allowable limits (the error of temperature is less than 0.3°C, and the error of pressure is less than 0.65%). HVAC operating parameters are fully monitored, closely and directly.Hệ thống tự động hóa tòa nhà (Building Automation System - BAS) hiện đang được ứng dụng rất nhiều trong các hệ thống tòa nhà cao tầng hiện đại. Mục tiêu chính của hệ BAS là giám sát và điều khiển tất cả các hệ thống trong tòa nhà thông minh bằng một hệ điều khiển duy nhất để tối ưu hiệu suất thực tế. Trong đó hệ điều hòa thông gió (HVAC) là một trong những hệ quan trọng nhất trong hệ BAS. Nội dung bài báo trình bày về kết quả sử dụng phần mềm Andover Continuum của hãng Schneider Electric vào việc lập trình điều khiển và thiết kế giao diện giám sát hệ thống điều hòa thông gió HVAC ứng dụng trong tòa nhà PVI (Hà Nội). Thông qua việc phân tích đối tượng chúng tôi đã đưa ra thuật toán điều khiển
xây dựng được mô hình hàm truyền điều khiển lưu lượng và áp suất bơm nước lạnh theo cấu trúc 2 mạch vòng điều chỉnh. Dựa trên phương pháp nghiên cứu mô phỏng kết hợp thực nghiệm hệ thống cho thấy các thông số điều khiển bám sát giá trị đặt với sai số nằm trong giới hạn cho phép (sai lệch nhiệt độ dưới 0,3°C và áp suất dưới 0,65%). Các thông số hệ HVAC được giám sát một cách trực tiếp, đầy đủ và chặt chẽ.