Bài báo này trình bày những kết quả nghiên cứu về ảnh hưởng của quy trình xử lý nhiệt đến tổ chức và cơ tính của thép Mn15Cr2V được sử dụng chế tạo răng gầu PC1250. Các kết quả nghiên cứu cho thấy: Khi thép được xử lý nhiệt với việc nung trung gian ở 650oC giữ nhiệt trong 02 giờ làm nguội ngoài không khí sau đó tiếp tục nung đến 1100oC giữ nhiệt trong 02 giờ và làm nguội nhanh trong nước cho được tổ chức hoàn toàn austenite
không có cacbit thô nằm ở biên giới hạt. Bằng phân tích hiện đại đã chỉ ra các cacbit nhỏ mịn như VC phân tán trong nền austenite. Giá trị độ dai va đập thu được của thép đạt tới 115J/cm2. Giá trị độ cứng của pha nền sau xử lý nhiệt là 223HB.The article presents the research results on the influence of heat treatment process on the microstructure and mechanical properties of Mn15Cr2V steel used to make PC1250 bucket teeth. The research results show that: When the steel was heated with intermediate heating at 650oC, was kept in 02 hours, then cool in the air, then continue, the steel was heated at 1100oC, was kept in 02 hours and cool down quickly in water. The microstructure of this steel was held full austenite
There are not carbides which were located at the grain boundaries. By modern analysis, there are has shown that fine carbides such as (Fe,Cr)7C3 VC are dispersed in the austenite matrix. The value of impact toughness obtained of steel reaches 115J/cm2. The hardness value of the base phase after heat treatment is 223HB.