Bài báo trình bày kết quả nghiên cứu ảnh hưởng của mức độ biến dạng đến tổ chức tế vi khi chuẩn bị tổ chức bán lỏng hợp kim nhôm AA7075 bằng phương pháp ép chu kỳ trong khuôn kín kết hợp gia nhiệt vùng 2 pha rắn - lỏng. Thực nghiệm cho thấy, khi mức độ biến dạng tăng, tổ chức tế vi thu được nhỏ mịn, đồng đều. Tuy vậy, khi mức độ biến dạng quá lớn (số chu kỳ ép lớn hơn 6) thì tổ chức thu được thay đổi không nhiều. Giá trị hợp lý khi ép chuẩn bị tổ chức bán lỏng hợp kim nhôm AA7075 là chu kỳ ép n = 5~6.This article presents the results of research on the influence of the deformation levels on the microstructure when preparing a semi-solid microstructure of AA7075 aluminum alloy using the multidirectional forging with heating in the two-phase zone. Experiments show that, as the deformation level increases, the microstructure becomes small, smooth, and uniform. However, when the deformation level is too large (the number of pressing cycles is greater than 6), the resulting organization does not change much. The reasonable value when pressing to prepare a semi-solid structure of AA7075 aluminum alloy is pressing cycle n = 5~6.