Nhằm đánh giá khả năng tích - xả của một số loại hệ thống tích nhiệt và ảnh hưởng của các điều kiện lắp đặt, vận hành tới thời gian sử dụng hệ thống thì cần thiết phải mô phỏng hoạt động bằng công cụ Mô phỏng động lực học chất lỏng bằng máy tính (CFD - ANSYS Fluent). Khi so sánh với thực nghiệm, chương trình mô phỏng cho kết quả chính xác. Thời gian tích và xả nhiệt của vật liệu cát ngắn hơn hỗn hợp dầu - cát, vật liệu có biến đổi pha cho thời gian tích và xả nhiệt dài nhất. Đối với pin cát, khi tăng số ống dẫn khí thì tổng thời gian sử dụng sẽ tăng, tăng nhiệt độ vào của khí nóng thì tổng thời gian tích - xả nhiệt không đổi. Kết quả mô phỏng là nền tảng để mở rộng ứng dụng của hệ thống tích nhiệt trong các hệ thống sử dụng năng lượng tái tạo một cách hiệu quả.To evaluate the storage and discharge capacity of some types of heat storage systems and the influence of installation and operating conditions on system usage time, it is necessary to simulate operations using the Computational fluid dynamic tool (CFD - ANSYS Fluent). After comparing the experimental and simulation results, the simulation program gives accurate results. The heat accumulation and release time of the sand material is shorter than that of the oil-sand mixture, the phase change material (PCM) has the longest heat accumulation and release time. For sand batteries, when increasing the number of air pipes, the total usage time will increase, if the inlet temperature of hot air rises, the total heat accumulation and discharge time will remain unchanged. The simulation results give the basis to extend the application of heat storage systems in systems that use renewable energy effectively.