Nghiên cứu khả năng tái sử dụng bột nhựa thải từ quá trình khoan, cắt sản xuất các bo mạch điện tử làm gạch bê tông ứng dụng trong xây dựng và so sánh chúng với các nhóm sản phẩm cùng loại theo tiêu chuẩn Việt Nam. Kết quả nghiên cứu bước đầu cho thấy bằng phương pháp cố định hoá rắn xử lý chất thải, các sản phẩm đóng rắn bột nhựa thải từ quá trình sản xuất bo mạch điện tử hầu như đáp ứng tốt về độ rò rỉ đồng (Cu) cho phép theo phương pháp ngâm chiết độc tính (Toxicity Characteristic Leaching Procedure – TCLP), cường độ nén cao đối với nhóm sản phẩm đóng rắn bằng xi măng tỷ lệ phối trộn xi măng:bộtnhựa thải là 70:30 với tỷ lệ nước:xi măng là 55:100. Các sản phẩm gạch bê tông đóng rắn từ bột nhựa thải cho kết quả phân tích độ rò rỉ Cu, độ bền nén đáp ứng yêu cầu môi trường, mẫu mã sản phẩm phù hợp với TCVN 6477:2011 về cường độ nén yêu cầu lớn hơn 5 Mpa và độ hút nước nhỏ hơn 14%.Từ khóa: Bo mạch điện tử, cố định hoá rắn, tái chế bột nhựa, vật liệu xây dựng.This paper studied the possibility of reusing plastic powder waste from the drilling, cutting in printed circuit boads to make concrete bricks used in construction and compare them with other product groups of the same type according to Vietnamese standards. The initial results showed that using the stabilization and solidification method, the solidificated products were almost well-suited for the Cu leakage allowed by TCLP method, high compressive strength at ratio cement:waste was 70:30 with standard water:cement ratio of 55:100. Bricks made from powder plastic waste met the environmental requirements of Cu leakage analysis, compressive strength and design in accordance with TCVN 6477:2011 regarding compressive strength required more than 5 Mpa and water absorption rate of less than 14%.Keywords: Printed circuit boards, stabilization-solidification, recycled plastic, construction products